OWN - Quintessenz Verlags-GmbH CI - Copyright Quintessenz Verlags-GmbH OCI - Copyright Quintessenz Verlags-GmbH TA - Int J Prosthodont JT - The International Journal of Prosthodontics IS - 1942-4426 (Electronic) IS - 0893-2174 (Print) IP - 4 VI - 35 PST - ppublish DP - 2022 PG - 410-413 LA - en TI - Comparative Evaluation of the Reproductive Trueness of Zirconia Crowns Fabricated Using Additive Manufacturing and Conventional Milling LID - 10.11607/ijp.7092 [doi] FAU - Miura, Shoko AU - Miura S FAU - Fujita, Takafumi AU - Fujita T FAU - Tsukada, Shohei AU - Tsukada S FAU - Teshigawra, Daisuke AU - Teshigawra D FAU - Saito-Murakami, Konatsu AU - Saito-Murakami K FAU - Fujisawa, Masanori AU - Fujisawa M CN - AB - Purpose: To evaluate the occlusal reproductive trueness of zirconia crowns fabricated using additive manufacturing (AM) and to compare the surface roughness of crowns fabricated using AM and conventional milling (CM). Materials and Methods: Crowns were manufactured using AM and CM on abutments with total occlusal convergence angles of 16 and 20 degrees. Results: The surface roughness of the AM crowns was less than that of the CM crowns. The differences in reproductions of the occlusal morphology of the abutment crown were greater at 16 degrees than at 20 degrees. Conclusion: AM could be an effective method for manufacturing zirconia crowns. AID - 1218559