PMID- 32320187 OWN - Quintessenz Verlags-GmbH CI - Copyright Quintessenz Verlags-GmbH OCI - Copyright Quintessenz Verlags-GmbH TA - Int J Prosthodont JT - The International Journal of Prosthodontics IS - 1942-4426 (Electronic) IS - 0893-2174 (Print) IP - 3 VI - 33 PST - ppublish DP - 2020 PG - 328-332 LA - en TI - Could Microwave Glazing Be Considered as an Alternative to Conventional Surface Finishing Methods of Ceramic Materials in Terms of Color Stability? LID - 10.11607/ijp.6412 [doi] FAU - Sanal, Fatma Ayse AU - Sanal F FAU - Kurt, Murat AU - Kurt M CN - AB - Purpose: To examine microwave heating for the purpose of ceramic glazing as an alternative to conventional methods in terms of color stability. Materials and Methods: Thirty disk-shaped specimens (11 × 2 mm) of VITA VM 9, VITA VM 13, VITA VMK 95, and IPS e.max Ceram veneers were prepared (n = 30 each). The specimens were further divided into three subgroups according to surface finishing procedure (polishing, conventional oven glazing, or microwave glazing [n = 10 each]). The related surface finishing procedure was applied according to the manufacturers' instructions. Color differences (ΔE) of the ceramic samples stored in a coffee solution at 37°C for 168 hours were determined using spectrophotometry. Data were analyzed using two-way ANOVA. The group differences were analyzed using Tukey HSD test. Results: Microwave-glazed specimens showed similar ΔE values to conventionally glazed specimens for the tested ceramics (P > .05). Polished specimens showed higher ΔE values than glazed specimens for the investigated ceramic materials, and the difference was significant for VITA VMK 95 and Vita VM9 (P ≤ .05). Conclusion: Microwave glazing has the advantage of decreasing glazing time to a few minutes and could be considered as an alternative method to conventional oven glazing and polishing with respect to color stability. AID - 850210