PMID- 32760928 OWN - Quintessenz Verlags-GmbH CI - Copyright Quintessenz Verlags-GmbH OCI - Copyright Quintessenz Verlags-GmbH TA - Int J Esthet Dent JT - International Journal of Esthetic Dentistry IS - 2198-591X (Print) IP - 3 VI - 15 PST - ppublish DP - 2020 PG - 344-354 LA - en TI - Comparative analysis of elastomeric die materials for semidirect composite restorations FAU - de Abreu, Joao Luiz AU - de Abreu J FAU - Katz, Steven AU - Katz S FAU - Sbardelotto, Cristian AU - Sbardelotto C FAU - Mijares, Dindo AU - Mijares D FAU - Witek, Lukasz AU - Witek L FAU - Coelho, Paulo G AU - Coelho P FAU - Hirata, Ronaldo AU - Hirata R CN - AB - Aim: Die silicone materials are used to build chairside composite restorations. The purpose of this study was to compare the flowability, dimension accuracy, and tear strength of four elastomeric die materials. Material and methods: Materials were divided into four groups: Mach-2 (M2), Scan Die (SD), GrandioSO Inlay System (GIS), and Impregum-F (IM). Flowability analysis was carried out using the shark fin test (SFT). For dimension accuracy, impressions were taken from a premolar Class I preparation and an elastomeric model was cast. Composite resin restorations were built and positioned into the premolar for gap measurement. The mean gap length was divided into three levels: acceptable (A), not acceptable (NA), and misfit (M). For tear strength, strip specimens were made with a V-shaped notch (n = 6). The specimens were tested in a universal machine until tear. All data were analyzed statistically with a confidence interval of 95%. Results: GIS showed the lowest flowability values, with no differences between IM, M2, and SD. For dimension accuracy, IM showed 100% 'A' gap values, followed by M2 (80%), SD (60%), and GIS (60%). For tear strength, IM showed the highest values, followed by M2, GIS, and SD. Conclusions: M2, SD, and IM had similar flowability, while GIS had the lowest. IM presented higher tear strength than M2, followed by GIS and SD. IM showed the highest degrees of acceptable gap filling, followed by M2. AID - 852406